美隆電子有限公司

Mayloon Electronic Co., Ltd.,

  • 增加字體大小
  • 預設字體大小
  • 減少字體大小

Fusible Resistor - RF series

E-mail 列印

RESISTOR

SINLOON® 溶斷保險絲電阻 FR SERIES
Power Rated: 1/4W ~ 3WS Fusible Resistor
Fusible Resistor - RF Series
EATURES igure
The Fusible resistor is applied to safety circuit in wide range of electronic sets. 溶斷電阻 按圖放大
Fusing Resistor - FR
Complete flame proof construction resistance range 0.33R ~ 1K ohm
Resistance tolerance  ±2%, ±5%.
There are 5 color band is in write color means wire wound fusible resistor - - -
The fusing time 60/sec Max.
NTRODUCTION - - -
FR Type (Standard)
Rated power : 1/4W ~ 2W; 1/2WS ~ 3WS.
Superior quality fusible resistors which are flameproof during operation - - -
These resistors fuse  in less than 30 seconds at 16 times rated power
XTERNAL DIMENSIONS
Type Power DIMENSION (mm) Dimension (本體尺寸)
L ΦD H Φd
FR025 1/4W 6.3±0.5 2.3±0.3 28±2 0.55±0.03
FR50S 1/2WS 6.3±0.5 2.3±0.3 28±2 0.55±0.03
FR50 1/2W 9.0±0.5 3.2±0.5 28±2 0.65±0.03
FR100S 1WS 9.0±0.5 3.2±0.5 28±2 0.65±0.03 -
FR100 1W 11.5±1.0 4.5±0.5 35±2 0.78±0.03
FR200S 2WS 11.5±1.0 4.5±0.5 35±2 0.78±0.03
FR200 2W 15.5±1.0 5.0±0.5 35±2 0.78±0.03
FR300S 3WS 15.5±1.0 5.0±0.5 35±2 0.78±0.03
ATED POWER
Type Power Limiting Element Resistance Resistance Operating
Voltage Range Tolerance temperature Range
FR025 1/4W 200V 1R~1KΩ G=±2% J=±5% -40~ +155
FR50S 1/2WS 250V 1R~1KΩ
FR50 1/2W 250V 1R~1KΩ
FR100S 1WS 300V 1R~1KΩ
FR100 1W 300V 1R~1KΩ
FR200S 2WS 350V 1R~1KΩ
FR200 2W 350V 1R~1KΩ
FR300S 3WS 400V 1R~1KΩ
Remark: The products value range for standard resistance, below or over this resistance on request please contact us. 返回
: 如有低於或高於規格參數阻值的要求請聯絡我們
 
歡迎您瀏覽本網站 WELCOME TO MAYLOON
Mayloon Electronic Company Limited Mayloon Lighting Company Limited

Mayloon on-line chat now

即時業務接洽
WhatsApp:91808452
QQ:1247069489
E-mail: peter@mayloon.com
TEL:852-2408 9788 M: 9180 8452

消息

美隆照明有限公司
承接換燈照明工程:
更新換舊
各類型照明燈具
瑩光燈管換LED燈管
包括:燈管支架/有罩燈盤/格柵燈盤等
歡迎來電查詢
MP.:91808452

Newsflash

封閉實際光輸出的控制回路

正确量測LED電源

 

封閉實際光輸出的控制回路

半導體照明這一新興領域的出現,使同時專長於電力電子學、光學和熱管理學(機械工程)這三個領域的工程師成為搶手人才。目前,在三個領域都富有經驗的工程師並不很多,而這通常意味著系統工程師或者整體產品工程師的背景要和這三大領域相關,同時他們還需盡可能與其他領域的工程師協作。系統工程師常常會把自己原領域養成的習慣或積累的經驗帶入設計工作中,這和一個主要研究數位系統的電子工程師轉去解決電源管理問題時所遇到的情況相同:他們可能依靠單純的模擬,不在試驗檯上對電源做測試就直接在電路板上佈線,因為他們沒有認識到:開關穩壓器需要仔細檢查電路板佈局;另外,如果沒有經過試驗台測試,實際的工作情況很難與模擬一致。

正確測量LED供電電源

標準電源設計中常見的習慣

善用每一分預算